Glock Pro Forums banner

G19 fail to load / stovepipe

7904 Views 13 Replies 10 Participants Last post by  sfguard
Folks, new gen 3 g19. 300+ rounds thru it no problems. Gun show last week. Certified glock armorer installed 3.5 lonewolf trg connector, extra power trigger spring, Glock extended slide stop, lonewolf extra large mag release. Shot 220 Remington umc thru it today. About 6 failed to load. Couple of stovepipes. Where to start looking for problem? Worried I've jacked up a perfect gun somehow? Thx for any help!
1 - 1 of 14 Posts
Non factory parts and odd powered springs. This will sound cliche but don't F with perfection.

In all seriousness though ... put the OEM spring back in it and you should be fine. I think you prob meant extra powered recoil spring and not trigger spring based on the fact you had stovepipes.
YEP. "If it ain't broke, don't fix it".
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top